Long Lounger Cat Climber with Facade

The Long lounger with a raised felt edge, so a sprawling cat stays put.

The Long lounger paired with its facade, a soft felt lip that runs along the open edge. For a cat that sleeps hard, rolls, or lands a little wide, the raised edge is the difference between a nap and a tumble. It reads as one clean piece on the wall.

Firm recycled PET felt throughout, rounded for face rubs, on the hidden stainless steel bracket. Bought together the pair costs a little less and comes matched in one finish.

Up in an afternoon

Each climber ships with its mounting hardware in the box: an Allen key, toggle bolts, screws, and wall plugs sized for hollow drywall or solid brick and concrete. The four piece sets add paper spacing templates, so you can plan the layout and mark the holes before a single one is drilled. One shelf goes up in a few minutes, and a whole wall is an afternoon. Tested to hold up to 55 lb (25 kg), so it takes a big cat landing at speed.

Felt from bottles, not trees

The felt is spun from 100 percent recycled PET, the same plastic drink bottles would otherwise become landfill. It is firm enough to hold a shelf's shape and soft enough that a cat rubs its face along the edge to claim it, and when it finally wears you swap the felt slices instead of the whole shelf.

Made in Brisbane

Pryde Pets is a family run studio in Brisbane, Australia, where the climbers are cut, sanded, and finished by hand. The shapes are modular on purpose: start with a single shelf or the four piece set, watch where the cat actually goes, then add steps, a lounger, or a nest to extend the route. Every piece lines up with what is already on the wall, so the setup grows with the cat instead of being a one time buy.